Legenda de stocks

Em stock

Artigos disponíveis para levantamento na loja ou expedição.

Categorias

O artigo foi adicionado ao carrinho com sucesso. Poderá alterar agora a quantidade ou posteriormente no carrinho.

QTD:

BOYA BY-M1000 Microfone Condensador de Diafragma Grande
Ref: 15820


DISPONIBILIDADE:

Em Stock
Unidades em loja: 2

Preencha este formulário para receber um e-mail informativo assim que este artigo for colocado em stock.

Descrição
Mais
acessórios
Avaliações (0)

BOYA BY-M1000 Microfone Condensador de Diafragma Grande

 

Key Features

  • Large-Diaphragm Condenser
  • Omnidirectional, Cardioid & Figure-8
  • -10 dB Pad Switch
  • 2-Position High-Pass Filter Switch
  • Included Shockmount & Pop Filter
  • Included Thread Adapter & XLR Cable

 

In the Box

  • BOYA BY-M1000 Large-Diaphram Multi-Pattern Condenser Studio Microphone
  • Pop Filter
  • Shockmount
  • XLR Cable (3m)

 

The BOYA BY-M1000 is a large-diaphragm condenser designed for recording in studio applications. Use it for miking vocals or instruments around your studio. It offers three polar patterns: cardioid, omnidirectional, and figure-8. All three polar patterns have their uses in the studio environment.

Omnidirectional gives you an even phase and frequency response all around the capsule. Cardioid deadens the back of the capsule, allowing you to mic sources closer to walls; this is the preferred polar pattern of the project or home studio. Figure-8 deadens both sides of the capsule, while the front and back have the same frequency and phase response; this is a wonderful choose for mono-miking two instruments while minimizing room coloration.

The mic itself boasts a smooth and flat frequency response between 20 Hz and 20 kHz. The two-position low-cut filter can help mitigate some rumble and clean up the signal in situations where low-end frequency is not wanted. The -10 dB pad is a boon when miking loud sources, such as drums. Switches for both are found on the mic itself.

The mic is fashioned out of metal, and runs off 24 to 48V phantom power, supplied from your preamp, console, or interface. A 10' mic cable is included, as is a shockmount, a pop filter, and a 3/8 to 5/8" thread adapter to accommodate all manner of mic stands.

 

Key Features at a Glance

  • Large gold-sputtered diaphragm
  • Great for studio and broadcast
  • Flat, wide-range frequency response
  • Omnidirectional, Figure-8, and Cardioid pickup pattern
  • Switchable low-cut filter at 150 Hz 
  • Selectable -10 dB pad
  • Included shockmount and pop filter
  • 24 or 48V phantom power
  • Standard XLR connector
  • 3m XLR cable included
  • Included 3/8" and 5/8" threads

 

Specs:

Microphone
Form Factor Stand/Boom Mount
Sound Field Mono
Capsule Condenser
Diaphragm 34 mm (Condenser)
Polar Pattern Cardioid, Figure-8, Omnidirectional
Pattern Selection Switched (Adjustable on Mic)
Orientation Side Address
Circuitry Solid-State
Pad -10 dB
High-Pass Filter 150 Hz
On-Board Controls Polar Pattern, High-Pass Filter, Pad
Performance
Frequency Range 20 Hz to 20 kHz
Impedance 200 Ohms
Sensitivity -33 dB
Signal-to-Noise Ratio 80 dB
Connectivity
Output Connectors (Analog) 1 x XLR 3-Pin Male (on Mic)
Cable Length 3 m
Power
Operating Voltage 24 to 48 V (Phantom Power)
Physical
Color Black
Mounting Shockmount (Included)
Construction Material Metal
Dimensions ø: 115 x H: 207 x W: 185 mm
Weight 812 g

Saiba a opinião dos nossos clientes sobre este artigo e deixe-nos também a sua avaliação.